Shop
E88 Pro Drone DIY Smart Kit
₹2,700.00One fully charged intelligent battery can support 20 minutes flight time, moreover, this package comes with two batteries, which means 40 minutes joyful flight time is available.
Electret Condenser Mic 9X7mm
₹19.00This Voice microphone is Multi-Channel and is suitable for mobile phones, telephones, tape recorders, voice-activated toys, computers, and other products. The sensitivity is in accordance with the IEC standard, and the sensitivity of “pa” is increased by 20dB,
EM-18 RF-ID Reader Module & Base With One Card
₹530.00High Range then EM-18 & also work on 5V directly.*TTL(TX, VCC & GND) Output available on board which helpful to connect device & interface with micro controller*On board 7805 voltage regulator available for sourcing regulated 5V @ upto 1A voltage to the board and connecting circuit.*Supportive With Raspberry Pi, DSP, AVR, PIC, 8051
ESP32 CAM WiFi Module Bluetooth with OV2640 Camera Module 2MP For Face recognization
₹429.00Wireless Module: ESP32-S WiFi 802.11 b/g/n + Bluetooth 4.2 LE module with PCB antenna, u.FL connector, 32Mbit SPI flash, 4MBit PSRAM.*External Storage: micro SD card slot up to 4GB
ESP32 Node MCU Wroom WiFi Cp2102 Supported Development Board
₹360.00High performance-price ratio small volume, easily embedded to other products strong function with support lwip protocol and freertos supporting three modes: Ap, sta, and ap+sta supporting lua program, easily to develop*Esp32 is already integrated antenna and rf balun, power amplifier, low-noise amplifiers, filters, and power management module*The entire solution takes up the least amount of printed circuit board area this board is used with 24 ghz dual-mode wi-fi and bluetooth chips by tsmc 40nm low power technology, power and rf properties best, which is safe, reliable, and scalable to a variety of applications
ESP8266 Node MCU WiFi Cp2102 Supported Development Board
₹289.00The development kit based on esp8266, integrates gpio, pwm, i2c, 1wire and adc all in one board; Support smart link smart networking*Nodemcu is the fast leading edge low cost technology to Wi-Fi; Power your development in the fastest way combination with nodemcu firmware*Modern high level mature lua based technology; It is an integrated unit with all available resources on board; It is super simple to complement your existing Arduino projects or any development board that has i or o pins available*USB: Micro USB port for power, programming and debugging and Reset and flash buttons
ESP8266-12E WiFi Wireless Module SMD Chip
₹145.00Compatible with Arduino, MicroPython; Default firmware: lastest MicroPython*For the user for the choice of ESP-12. it doesn’t matter. The enhanced version ESP8266-12E is fully compatible with the firmware of ESP-12. It has the additional six pins with IO and SPI ports on the basis of the ESP-12. then develop more convenient.*Chipset: ESP-12E – 802.11 b/g/n, Integrated low power 32-bit MCU; Integrated 10-bit ADC; Integrated TCP/IP protocol stack, TR switch, balun, LNA, power amplifier and matching network, PLL, regulators, and power management units*Supports antenna diversity Wi-Fi 2.4 GHz, support WPA/WPA2 Support STA/AP/STA+AP operation modes Support Smart Link Function for both Android and iOS devices Support Smart Link Function for both Android and iOS devices
F450 / Q450 Quadcopter Frame DIY Kit With Bldc Motors, ESC and 1045 Propeller
₹3,250.00F450 / Q450 Quadcopter Frame DIY Kit With Bldc Motors, ESC and 1045 Propeller. The F450 quadcopter combo drone kit is a complete bundle for making a basic quadcopter which comes in all quadcopter items without a flight controller and wireless transmitter and receiver remote.
F450 Quadcopter Frame With PCB Board For Drone
₹535.00450mm quad frame built from quality materials. The main frame is glass fiber while the arms are constructed from ultra durable polyamide nylon. This version of the F450 features integrated PCB connections for direct soldering of your ESCs.This eliminates the need for a power distribution board or messy multi-connectors keeping your electronics layout very tidy. F450 also comes with stronger molded arms, so no more arm breakage at the motor mount on a hard landing.
F450/Q450 Quadcopter DIY Kit With Bldc Motors, ESC, Lipo Battery, B3 Charger and 1045 Propeller
₹4,799.00This is Quadcopter Economy Combo Kit which will help you become a quadcopter pilot. Simply get out the soldering iron, put on your safety goggles, and begin soldering. This Economy kit has very good products and is available at affordable cost.
Female to Female Jumper Wires Strip of 40 Wires
₹62.00It is high quality & reliable breadboard jumper cable, which is used in many applications for experimental purpose & learning boards
Finger Detecting Pulse Heartbeat Sensor Module (IR Based)
₹119.00This project uses bright infrared (IR) LED and a phototransistor to detect the pulse of the finger, a red LED flashes with each pulse.
FT232RL USB TO TTL 5V 3.3V Download Cable To Serial Adapter Module for Arduino
₹159.00FT232RL USB TO TTL 5V 3.3V Download Cable To Serial Adapter Module for Arduino.
Single chip USB to asynchronous serial data transfer interface.
General Purpose Printed Circuit Zero PCB Board of 80 x 55 mm (2 Pieces)
₹65.00The epoxy glass fiber forms the substrate on which the copper foil is hot pressed only on one side and the other side remains bare. It has a copper core for strength and the substrate acts as electrical insulation.*It Is Ideal For Hobbyists, School / College, And Engineering Students. Widely Used For Electronic Projects.
GL-12 840 Points Solderless Breadboard For Circuit Making & Testing
₹72.00Reusable for fast build a prototype of an electronic circuit will accept transistors, diodes, LEDS, resistors, capacitors and virtually all types of components*Adhesive sheet on the back side of the board, multiple breadboards can be spliced together too*840 Tie Points: 128 groups of 5 connected terminals, 8 bus of 25 connected terminals*No soldering required or can modify or revise the circuits easily, fit for jumper wire of 0.8mm diameter standard 2.54mm hole spacing
GPS Module Ublox Neo-6M V2 With EEPROM
₹345.00UBlox software for configuration and viewing data can be downloaded from U blox directly*UBLOX NEO-6M GPS Module has a battery for power backup and EEPROM for storing configuration settings. It has also high sensitivity for indoor applications.*The Ublox GPS module has serial TTL output, it has four pins: TX, RX, VCC, and GND.*you can apply it on your smart robot car for automatic returning or be heading to a certain destination, making it a real “smart” bot!
GPS Neo 8m For Flight Controllers
₹2,329.00Ublox NEO-M8N GPS Module with Compass for APM with extra connector for Pixhawk FC is the new Ublox Neo-M8N GPS module that includes an HMC5883L digital compass. This module has a high level of sensitivity and features active circuitry for the ceramic patch antenna. It also comes enclosed in the plastic case to protect the module from the elements. This module outputs precise position updates at 10Hz and also has a rechargeable backup battery for warm starts. The Ublox NEO-M8N is configured to run at a baud rate of 38400 and can be used with Pixhawk and APM
